Zone Isolation Hydro Fracture

      Zone isolation hydro fracturing is most commonly used in situation where a lot of water is needed. Normally this would consist of municipal wells, community wells and irrigation wells, however there are various circumstances and areas of the country where zone isolation hydro fracture is needed on domestic wells.

     This hydro fracture process is by far the most effective, with a success rate of over 99% and increased well yields up to  20 gpm (Gallons per minute) and more this process is second to none.

     This process is normally repeated up to 10 times in a well, starting from the bottom of the well and working your way out. It is far more expensive than a single packer hydro fracture and takes much longer to perform (8-12 hours) but it will get you more water than the single packer process.